Owners Manual

4. Press the PERC card to firmly seat in the system board connector.

Figure 63. Installing the PERC card

5. Close the lever on the PERC card.

Next steps

1. Connect the cable to the PERC card.

2. Follow the procedure listed in After working inside your sled on page 17.

Removing the Jumbo PERC card

Prerequisites

1. Follow the safety guidelines listed in the Safety instructions.

2. Follow the procedure listed in the Before working inside your sled.

3. Disconnect the cable connected to the Jumbo PERC card.

Steps

1. Pull the two blue pull tags to raise the lever up on the Jumbo PERC card.

2. Holding both the blue pull tags, lift the Jumbo PERC card away from the system.

3. Install the connector cap on the I/O connector of the Jumbo PERC card.

Installing and removing system components