Owners Manual

Figure 85. Installing the system board

4. Lower the system board and install the screws to secure the system board to the system.

Next steps

1. Install the following:

a. Internal USB key

b. iDRAC card

c. IDSDM

d. Mini Mezzanine card

e. Mezzanine card(s)

f. PERC card

g. Drive cage

h. Drive backplane

i. Drives

NOTE: Ensure that you reinstall the drives in their original locations.

j. BBU module

k. Memory modules

l. Processor(s) and heat sink(s)

m. Air shroud

2. Remove the plastic I/O connector cover from the back of the system.

3. Install the sled in the enclosure.

4. Follow the procedure listed in After working inside your sled on page 17.

5. Ensure that you:

Installing and removing system components