Owners Manual

ManualsBrandsDell ManualsC SeriesPowerEdge MX740c

Table 6. Temperature specifications

Temperature Specifications

Storage –40°C to 65°C (–40°F to 149°F)

Continuous operation (for altitude less than 950 m or

3117 ft)

10°C to 35°C (50°F to 95°F) with no direct sunlight on the

equipment.

Maximum temperature gradient (operating and

storage)

20°C/h (68°F/h)

Table 7. Relative humidity specifications

Relative humidity Specifications

Storage 5% to 95% RH with 33°C (91°F) maximum dew point. Atmosphere

must be noncondensing always.

Operating 10% to 80% relative humidity with 29°C (84.2°F) maximum dew

point.

Table 8. Maximum vibration specifications

Maximum vibration Specifications

Operating 0.26 G

rms

at 5 Hz to 350 Hz (all operation orientations).

Storage 1.87 G

rms

at 10 Hz to 500 Hz for 15 min (all six sides tested).

Table 9. Maximum shock specifications

Maximum shock Specifications

Operating Six consecutively executed shock pulses in the positive and negative x,

y, and z axes of 6 G for up to 11 ms.

Storage Six consecutively executed shock pulses in the positive and negative x,

y, and z axes (one pulse on each side of the system) of 71 G for up to

2 ms.

Table 10. Maximum altitude specifications

Maximum altitude Specifications

Operating

3048 m (10,000 ft)

Storage 12,000 m (39,370 ft)

Table 11. Operating temperature derating specifications

Operating temperature derating Specifications

Up to 35°C (95°F) Maximum temperature is reduced by 1°C/300 m (1°F/547 ft) above

950 m (3,117 ft).

35°C to 40°C (95°F to 104°F) Maximum temperature is reduced by 1°C/175 m (1°F/319 ft) above

950 m (3,117 ft).

40°C to 45°C (104°F to 113°F) Maximum temperature is reduced by 1°C/125 m (1°F/228 ft) above

950 m (3,117 ft).

Particulate and gaseous contamination specifications

The following table defines the limitations that help avoid any equipment damage or failure from particulates and gaseous

contamination . If the levels of particulates or gaseous pollution exceed the specified limitations and result in equipment damage

or failure, you may must rectify the environmental conditions. Remediation of environmental conditions is the responsibility of

the customer.

Technical specifications