Reference Guide

56 Dell EMC PowerEdge MX SmartFabric Deployment Guide
f. Under Tagged Networks, select the checkbox next to each VLAN that the uplink will be tagged.
The uplink is a tagged member of all six VLANs in this example as shown in Figure 39.
g. If the uplink will be an untagged member of a VLAN, select the VLAN from the drop-down list next
to Untagged Network. In this example, this is left at None.
Note: If the uplink is an untagged member of a VLAN, see the Cisco ACI documentation for setting the
corresponding EPG to access (untagged) mode in ACI.
Tagged and untagged networks selected
h. Click Finish.
SmartFabric creates the uplink object. If the connected Cisco ACI vPC is configured correctly, as shown in the
attachment Scenario 3 – APIC config steps.pdf, the uplink comes up and the status for the fabric changes
to Ok on the Devices > Fabric page as shown in Figure 40.
SmartFabric status after uplink is created