Users Guide

Table 7. BIOS setup screen (continued)
Option Description
Dimms This option is set to Disable by default.
NVDIMM-N
Interleave
Enables or disables interleaving on NVDIMM-N. When Enabled, NVDIMM-N interleaving will
follow the same interleaving policy that applies to RDIMMs. Volatile RDIMM interleaving policy is
not affected by this option. RDIMM system memory and NVDIMM-N persistent memory will
remain as two distinct memory regions.
This option is set to Disable by default.
Battery Status Indicates if the NVDIMM-N battery is ready. Battery Status can display one of the following
states:
● Present-Ready
● Present-Offline
● Not-Present
The following settings are applicable to each NVDIMM-N present in the server
Table 8. NVDIMM-N
Option Description
NVDIMM-N Memory
Location
Specifies the memory slot location of the NVDIMM-N.
NVDIMM-N Memory Size Specifies information on the capacity of the NVDIMM-N.
NVDIMM-N Memory
Speed
Specifies information on the operating speed of the NVDIMM-N.
NVDIMM-N Memory
Firmware version
Specifies information on the current firmware version on the NVDIMM-N.
NVDIMM-N Memory
Serial Number
Specifies information on the serial number of the NVDIMM-N.
Remaining Rated Write
Endurance [%]
Specifies information on the remaining NVDIMM-N flash life-time in terms of percentage.
NVDIMM-N Factory Reset
and Secure Erase
Enables resetting and clearing data on the specific NVDIMM-N, and results in loss of data on that
specific NVDIMM-N.
Please note that if any option was changed by mistake, press ESC to exit each setup screen, and select No when prompted at
the screen below to discard all changes. Alternatively, options can be restored to the correct settings before responding Yes to
the prompt below.
BIOS
21