Users Guide

62 Dell EMC PowerEdge MX SmartFabric Configuration Guide with Cisco ACI
5.4 Cisco ACI validation
5.4.1 Verify vPC configuration
Verify the vPC connection from the Cisco ACI fabric to the Dell MX SmartFabric VLT, as shown in Figure 52,
that it is up and properly configured to allow the designated VLANs and EPGs. This is done as follows:
1. In the APIC GUI, click Fabric > Inventory > Pod name > Leaf name > Interfaces > vPC Interfaces
and drill down to the applicable port channel vPC policy group as shown in Figure 52.
2. Verify that the port channel shows as lacp-active and that the Oper State shows as Up.
Cisco ACI vPC port channel and interfaces