Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX750c Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge MX750c system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- PowerEdge MX750c sled
- Sled cover
- Air shroud
- Processor and memory module blank
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Control panel
- System memory
- Processor and heat sink module
- PERC card
- Optional IDSDM module
- M.2 BOSS card
- Mezzanine cards
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 33. PCIe cabling diagram of configuration 4 - 6 x 2.5-inch Universal backplane with H755 MX
Table 9. Connector descriptions for PCIe with H755 MX
From To
BP_PWR_1 (backplane power connector) SIG_PWR_0 (system board power connector)
BP_DST_PA1 (backplane PCIe 1 connector, cable marking BP
PA1)
CTRL_SRC_PA1 (PCIe connector of H755 MX controller card,
cable marking CTRL_PA1)
BP_DST_PB1 (backplane PCIe 2 connector, cable marking BP
PB1)
CTRL_SRC_PA1 (PCIe connector of H755 MX controller card,
cable marking CTRL_PA1)
BP_DST_PA2 (backplane PCIe 3 connector, cable marking BP
PA2)
CTRL_SRC_PA2 (PCIe connector of H755 MX controller
card, cable marking CTRL_PA2)
Figure 34. SATA cabling diagram of configuration 5 - 6 x 2.5-inch SAS/SATA backplane with on board SATA
Installing and removing system components
41