Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX750c Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge MX750c system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- PowerEdge MX750c sled
- Sled cover
- Air shroud
- Processor and memory module blank
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Control panel
- System memory
- Processor and heat sink module
- PERC card
- Optional IDSDM module
- M.2 BOSS card
- Mezzanine cards
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Table 29. Mezzanine card riser configurations (continued)
Mezzanine card category Description Slot priority Maximum cards
(Fl)
QLogic QME2742 (FC32 DP) Mezzanine slot C (mini-Mezz
slot)
1
Storage PERC 9: HBA330 MMZ Mezzanine slot C (mini-Mezz
slot)
1
PERC 10: H745P MX V3 Mezzanine slot C (mini-Mezz
slot)
1
PERC 11: HBA350i PERC connector 1
PERC 11: H755 MX PERC connector 1
Removing the Mezzanine card
Prerequisites
1. Follow the safety guidelines listed in Safety Instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Use the Phillips #2 screwdriver, loosen the captive screws that secure the Mezzanine card to the system.
2. Lift the Mezzanine card out of the sled.
NOTE: To prevent damage to Mezzanine card, you must hold the card only by its edges.
Figure 76. Removing the Mezzanine-A card
Installing and removing system components
83