Owners Manual

Figure 75. Installing the M.2 BOSS module

Next steps

1. Install the air shroud on the system board.

2. Install the PEM.

3. Follow the procedure listed in the After working inside your sled.

Removing the M.2 SATA card

Prerequisites

1. Follow the safety guidelines listed in the Safety instructions section.

2. Follow the procedure listed in the Before working inside your sled.

3. Remove the PEM.

4. Remove the M.2 BOSS module.

Steps

1. Using the Phillips #1 screwdriver, remove the screw on the M.2 BOSS module.

2. Pull the SATA card out of the connector and lift the card away from the module.

Installing and removing sled components