Owners Manual

Figure 76. Removing the M.2 SATA card

Next steps

1. Install the M.2 SATA card.

Installing the M.2 SATA card

Prerequisites

1. Follow the safety guidelines listed in the Safety instructions section.

2. Follow the procedure listed in the Before working inside your sled.

Steps

1. Align the M.2 SATA card at angle of 45 degrees with the SATA connector on the M.2 BOSS module.

2. Press the M.2 SATA card into the SATA connector until firmly seated in place.

3. Push down the M.2 SATA card and using Phillips #1 screwdriver, secure the M.2 SATA card to the module.

Installing and removing sled components