Owner's manual
Table Of Contents
- Contents
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Opening and Closing the System
- Cooling Shroud
- System Battery
- Optical Drive
- Configuring the Boot Drive
- Hard Drives
- Installing a SAS Controller Card
- Fan Assembly
- Optional PCI Fan Assembly
- Power Supply
- Expansion Cards
- Riser Card
- System Memory
- Processor
- Control Panel Assembly (Service-Only Procedure)
- System Board (Service-Only Procedure)
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Responding to a Systems Management Software Alert Message
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting the Power Supply
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting an Optical Drive
- Troubleshooting a Hard Drive
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessor
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
About Your System 21
Decreasing
available memory
One or more memory
modules might be
improperly seated or faulty.
Reinstall the memory
modules and, if necessary,
replace them. See "System
Memory" on page 81.
See "Troubleshooting
System Memory" on
page 108.
Diskette read
failure
Faulty or improperly
inserted diskette.
Replace the diskette.
Diskette subsystem
reset failed
Faulty diskette drive or
optical drive controller.
Ensure that the diskette
drive and optical drive
cables are properly
connected. See
"Troubleshooting a USB
Device" on page 102 and
"Troubleshooting an
Optical Drive" on page 110.
If the problem persists, see
"Getting Help" on
page 127.
Drive not ready Diskette missing or
improperly inserted in
diskette drive.
Reinsert or replace the
diskette.
Error: Incorrect
memory
configuration.
Ensure memory in
slots DIMM1_A and
DIMM1_B, DIMM2_A
and DIMM2_B match
identically in
size, speed and
rank.
The installed memory
modules are not matched
pairs.
See "Memory Module
Installation Guidelines" on
page 81.
Table 1-4. System Messages (continued)
Message Causes Corrective Actions
book.book Page 21 Thursday, August 30, 2007 3:30 PM