Owner's manual
Table Of Contents
- Contents
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Opening and Closing the System
- Cooling Shroud
- System Battery
- Optical Drive
- Configuring the Boot Drive
- Hard Drives
- Installing a SAS Controller Card
- Fan Assembly
- Optional PCI Fan Assembly
- Power Supply
- Expansion Cards
- Riser Card
- System Memory
- Processor
- Control Panel Assembly (Service-Only Procedure)
- System Board (Service-Only Procedure)
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Responding to a Systems Management Software Alert Message
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting the Power Supply
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting an Optical Drive
- Troubleshooting a Hard Drive
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessor
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
Installing System Components 59
Figure 3-5. Replacing the Battery
8
Reinstall the riser card. See "Installing the Riser Card" on page 80.
9
Install the cooling shroud. See "Installing the Cooling Shroud" on page 57.
10
Close the system. See "Closing the System" on page 55.
11
Enter the System Setup program to confirm that the battery operates
properly.
12
From the main screen, select
System Time
to enter the correct time and
date.
Also, re-enter any system configuration information that is no longer
displayed on the System Setup screens, and then exit the System Setup
program.
13
To test the newly installed battery, see "Troubleshooting the System
Battery" on page 106.
1 battery 2 battery socket 3 retention tab
1
2
3
book.book Page 59 Thursday, August 30, 2007 3:30 PM