Owner's manual
Table Of Contents
- Contents
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Opening and Closing the System
- Cooling Shroud
- System Battery
- Optical Drive
- Configuring the Boot Drive
- Hard Drives
- Installing a SAS Controller Card
- Fan Assembly
- Optional PCI Fan Assembly
- Power Supply
- Expansion Cards
- Riser Card
- System Memory
- Processor
- Control Panel Assembly (Service-Only Procedure)
- System Board (Service-Only Procedure)
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Responding to a Systems Management Software Alert Message
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting the Power Supply
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting an Optical Drive
- Troubleshooting a Hard Drive
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessor
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
92 Installing System Components
8
Remove all PCI expansion cards installed on the riser card. See "Removing
an Expansion Card" on page 78.
9
Remove the riser card. See "Removing the Riser Card" on page 79.
10
Disconnect the chassis intrusion cable from the INTRUSION_SWITCH
connector on the system board.
11
Disconnect the two power cables from the 12V and PWR_CONN
connectors on the system board. See Figure 6-2.
12
Pull up on the plunger that secures the system board tray to the chassis
floor. See Figure 3-21.
13
Using the tab on the system board tray, slide the system board forward
(toward the front of the system) and lift the assembly up and out of the
chassis. See Figure 3-21.
14
Lay the system board tray down on a smooth, nonconductive work surface.
book.book Page 92 Thursday, August 30, 2007 3:30 PM