Owners Manual

Figure 75. Removing the LCD control panel board—four hard drive chassis

screw (2) 2. control panel connector cable

3. display module cable 4. LCD control panel board

5. USB connector cable 6. standoff on the chassis (2)

Next steps

1. Install the LCD control panel assembly.

2. Follow the procedure listed in the After working inside your system section.

Related tasks

Installing the LCD control panel assembly

Prerequisites

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform troubleshooting and

simple repairs as authorized in your product documentation, or as directed by the online or telephone service and

support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow

the safety instructions that are shipped with your product.

1. Follow the safety guidelines listed in Safety instructions section.

2. Follow the procedure listed in the Before working inside your system section.

3. Keep the Phillips #2 screwdriver ready.

Steps

1. Align the tabs on the control panel with the notches on the chassis.

2. Route the LCD cable through the cable retention clip.

3. Push the control panel toward the chassis until it snaps into place.

4. Align and install the LCD control panel board.

5. Secure the board in place with screws.

Installing and removing system components

111