Owners Manual

Figure 18. Removing the intrusion switch

1. intrusion switch 2. intrusion switch slot

3. intrusion switch cable 4. intrusion switch connector on the system board

5. cable routing clip (2)

Next steps

1. Install the intrusion switch.

2. Follow the procedure listed in After working inside your system

Related tasks

Installing the intrusion switch

Prerequisites

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform troubleshooting and

simple repairs as authorized in your product documentation, or as directed by the online or telephone service and

support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow

the safety instructions that are shipped with your product.

1. Ensure that you follow the Safety instructions.

2. Follow the procedure listed in Before working inside your system.

Steps

1. Slide the intrusion switch into the intrusion switch slot.

2. Route the intrusion switch cable through the cable routing clips.

3. Connect the intrusion switch cable to the connector on the system board.

Installing and removing system components