Owners Manual

2. Align the following:
a) Guide on the expansion card riser with the guide pin on the system board.
b) Expansion card riser connector with the connector on the system board.
3. Lower the expansion card riser until the expansion card riser is firmly seated in the connector on the system board.
4. Close the expansion card riser latch.
Figure 52. Installing the expansion card riser
1.
expansion card riser 2. guide on the expansion card riser
3. guide pin on the system board 4. riser connector on the system board
5. slot on the chassis 6. expansion card latch
Next steps
Follow the procedure listed in the After working inside your system section.
1. If removed, connect the PERC card LED cable.
2. Follow the procedure listed in the After working inside your system section.
Related tasks
Installing an expansion card
Removing an expansion card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Disconnect any cables connected to the expansion card or expansion card riser.
4. If installed, remove the expansion card riser.
Steps
1. Hold the expansion card by its edges and remove it from the expansion card riser connector.
2. If you are removing the card permanently, install a filler bracket in the empty expansion card slot and close the expansion card latch.
NOTE:
You must install a filler bracket over an empty expansion card slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in
proper cooling and airflow inside the system. The filler bracket is necessary to maintain proper thermal conditions.
88 Installing and removing system components