Owners Manual

2. If removed, install the SD cards.

3. Follow the procedure listed in the After working inside your system section.

Related tasks

Removing an optional internal SD card

Installing an optional internal SD card

Installing the optional internal dual SD module

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and

simple repairs as authorized in your product documentation, or as directed by the online or telephone service and

support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow

the safety instructions that are shipped with your product.

1. Follow the safety guidelines listed in the Safety instructions section.

2. Follow the procedure listed in the Before working inside your system section.

NOTE: Temporarily label each SD card with its corresponding slot before removal.

Steps

1. Locate the internal dual SD module (IDSDM) connector on the system board. To locate the IDSDM connector, see the System board

connectors section.

2. Align the IDSDM with the connector on the system board.

3. Push the IDSDM until it is firmly seated on the system board.

Figure 69. Installing the optional internal dual SD module

a. IDSDM

b. pull tab

c. IDSDM connector

Next steps

1. Install the SD cards.

NOTE: Re-install the SD cards into the same slots based on the labels you had marked on the cards during removal.

2. Follow the procedure listed in the After working inside your system section.

Installing and removing system components

105