Owners Manual

Steps
1. If installed, remove the optical drive blank, and then press the blue release tab at the back of the blank and push the blank
out of the system.
2. Align the optical drive with the optical drive slot on the front of the chassis.
3. Slide the optical drive into the slot until the latch snaps into place.
4. Connect the power and data cable to the back of the drive.
5. Route the power and data cable through the cable routing guides on the system chassis.
Figure 33. Installing the optical drive
1.
optical drive 2. data cable
3. power cable 4. release tab
Next steps
1. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 62
Related tasks
Before working inside your system on page 63
After working inside your system on page 63
Cooling fans
Your system supports five cooling fans. A fan blank is pre-installed on the first cooling fan slot (FAN1).
NOTE: Hot-swap removal or installation of the fans is not supported.
NOTE: Each fan is listed in the systems management software, referenced by the respective fan number. If there is a
problem with a particular fan, you can easily identify and replace the proper fan by noting the fan numbers on the cooling
fan assembly.
The following table lists the fan configuration which shows the various fan configurations based on the processor configuration
in the system.
92
Installing and removing system components