Reference Guide

Table 18. System Profile Settings details (continued)
Option Description
Determinism Slider Set the system determinism by Power Determinism or Performance Determinism. This
option is set to Power Determinism by default.
Efficiency Optimized Mode Efficiency Optimized Mode maximizes Performance-per-Watt by opportunistically reducing
frequency/power. Enables or disables the Efficiency Optimized Mode.
Algorithm Performance
Boost Disable (ApbDis)
Enables or disables the Algorithm Performance Boost Disable (ApbDis). This option is set to
Disabled by default.
Dynamic Link Width
Management (DLWM)
Reduces the xGMI link width between sockets from x16 to x8 (default), when no traffic is
detected on the link. This option is set to Unforced by default.
System Security
To view the System Security screen, power on the system, press F2, and click System Setup Main Menu > System BIOS >
System Security.
Table 19. System Security details
Option Description
CPU AES-NI Improves the speed of applications by performing encryption and decryption by using
the Advanced Encryption Standard Instruction Set (AES-NI). This option is set to
Enabled by default.
System Password Sets the system password. This option is set to Enabled by default and is read-only if
the password jumper is not installed in the system.
Setup Password Sets the setup password. This option is read-only if the password jumper is not installed
in the system.
Password Status Locks the system password. This option is set to Unlocked by default.
Table 20. TPM 1.2 security information
Option Description
TPM Security
NOTE: The TPM menu is available only when the TPM module is installed.
Enables you to control the reporting mode of the TPM. The TPM Security option is set to Off by
default. You can only modify the TPM Status, and TPM Activation if the TPM Status field is set to
either On with Pre-boot Measurements or On without Pre-boot Measurements.
When TPM 1.2 is installed, the TPM Security option is set to Off, On with Pre-boot Measurements,
or On without Pre-boot Measurements.
When TPM 2.0 is installed, the TPM Security option is set to On or Off. This option is set to Off by
default.
TPM Information Changes the operational state of the TPM. This option is set to No Change by default.
TPM Firmware Indicates the firmware version of the TPM.
TPM Status Specifies the TPM status.
TPM Command Controls the Trusted Platform Module (TPM). When set to None, no command is sent to the TPM.
When set to Activate, the TPM is enabled and activated. When set to Deactivate, the TPM is disabled
and deactivated. When set to Clear, all the contents of the TPM are cleared. This option is set to None
by default.
Table 21. TPM 2.0 security information
Option Description
TPM Information Changes the operational state of the TPM. This option is set to No Change by default.
Pre-operating system management applications 15