Owners Manual
Table Of Contents
- Dell EMC PowerEdge R6525 Installation and Service Manual
- Contents
- About this document
- System overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Cable routing
- RIO card
- Tube clip
- Optional front bezel
- System cover
- Drive backplane cover
- Control panel
- VGA module
- Air shroud
- Cooling fan
- Drives
- Drive backplane
- Rear drive module
- Front PERC module
- System memory
- Processor and heat sink
- Expansion cards and expansion card risers
- Optional serial COM port
- Optional IDSDM module
- MicroSD card
- M.2 SSD module
- BOSS S2 card (optional)
- System battery
- Optional internal USB card
- Intrusion switch module
- Optional OCP card
- Power supply unit
- Trusted Platform Module
- System board
- LOM card and rear I/O board
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Cooling fan
Removing a cooling fan module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 26.
2. Follow the procedure listed in Before working inside your system on page 27.
3. If installed, remove the air shroud.
Steps
Holding the orange and black edges on the fan module, lift the cooling fan module horizontally to disconnect from the connector
on the system board.
NOTE: The procedure to remove standard, high performance (silver grade), or high performance (gold grade) fan module is
same.
Figure 49. Removing a cooling fan module
WARNING: Ensure not to tilt or rotate the cooling fan module while removing from the system.
Next steps
1. Replace a cooling fan module.
Installing a cooling fan module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 26.
2. Follow the procedure listed in Before working inside your system on page 27.
3. If installed, remove the air shroud.
Steps
1. Align and place the fan module connector horizontally with the connector on the system board.
Installing and removing system components
53