Users Guide
Table Of Contents
- Dell Technologies Host Bus Adapter User's Guide HBA355i and HBA355e
- Dell HBA355i and Dell HBA355e
- Dell HBA355i
- Dell HBA355i front card
- Dell HBA355e
- Dell HBA355i and Dell HBA355e technical specifications
- PowerEdge systems supported by Dell HBA355i
- PowerEdge systems supported by Dell HBA355e
- Operating systems supported by Dell HBA355i and Dell HBA355e
- MD1400 and MD1420 enclosure support for Dell HBA355e
- Port support matrix for dual path on the same MD1400 and MD1420 enclosure
- ME484 enclosure support for Dell HBA355e
- Port support matrix for dual path on the same ME484 enclosure
- Tape drive support for Dell HBA355e
- Applications supported by Dell HBA355i and Dell HBA355e
- Dell HBA355e enclosure support
- Features of Dell HBA355i and Dell HBA355e
- Installation and removal of cards
- Safety instructions
- Before working inside your system
- After working inside your system
- Remove the Dell HBA355i adapter
- Install the Dell HBA355i adapter
- Remove the Dell HBA355i front card
- Install the Dell HBA355i front card
- Remove the Dell HBA355e adapter
- Install the Dell HBA355e adapter
- Connect Dell HBA355e to the storage enclosure
- Driver support Dell HBA355i and Dell HBA355e
- Manage Dell HBA355i and Dell HBA355e cards using HII configuration utility
- Updating the firmware of Dell HBA355i and Dell HBA355e
- Getting help
- Troubleshooting
- Known issues
- VendorID and ProductID for tape drives
- System reserved partition after Windows installation
- Device settings in HII shows PCIe slot information
- Intermittent RSODs appears when a faulty drive is connected to HBA
- Selecting drive for operating system installation in legacy mode
- Adapter configuration change message
- Incompatible firmware image when incorrect payload is used
- Additional disks displayed in the command line interface
- Known issues
- Documentation resources
Applies to HBA355i
Adapter configuration change message
Description When you perform controller migration multiple times between systems, Legacy BIOS displays the
message Adapter configuration may have changed, reconfiguration is suggested.
Cause This error indicates that corresponding drives attached to the controller might not be enumerated
properly.
Solution Avoid controller migration multiple times between systems.
Applies to HBA355i, HBA355e
Incompatible firmware image when incorrect payload is used
Description If you have selected an incorrect firmware payload using the PERC CLI to update the controller firmware,
the controller is updated with an incompatible firmware image without any notification.
Cause Incorrect firmware payload is selected.
Solution Select the correct firmware and run the firmware update again.
Applies to HBA355i, HBA355e
Additional disks displayed in the command line interface
Description
If a ME484 enclosure is connected to HBA355e, additional disks with 0 KB are displayed in the physical
disklist (PDlist) output of the PERC CLI commands (show and show all).
Applies to HBA355e
38 Troubleshooting