Concept Guide
• Make the changes using the
System Profile Custom
selection.
•Set
System Profile
in BIOS to
Custom
mode.
•Set
CPU Power Management
to
Maximum Performance
mode.
•Set
Turbo Boost
mode to
Enabled
.
You must enable DPAT with a controlledturbo command using one of the
following modes:
• Dell Remote Access Controller Admin (RACADM)
• Web Services for Management (WSMAN)
• Dell OpenManage Deployment Toolkit (DTK)
Enabling DPAT Using RACADM (Firmware RACADM: SSH or Telnet Session)
NOTE: Ensure that LC and CSIOR are enabled before performing the configuration.
1
Set
ControlledTurbo
to
Enable
by running the following command:
$ racadm set bios.procsettings.controlledturbo
Enabled
2
Create commit and host reboot jobs by using the
jobqueue
command:
$ racadm jobqueue create BIOS.Setup.1-1 -r pwrcycle
-s TIME_NOW -e TIME_NA
3
Reboot the server and run CSIOR for the setting to take effect.
NOTE: The BIOS settings only take effect after you reboot the server and run CSIOR.
Attribute value names are case sensitive.
Disabling DPAT Using RACADM (Firmware RACADM: SSH or Telnet
Session)
1
Set
ControlledTurbo
to
Disable
by running the following command:
$ racadm set bios.procsettings.controlledturbo
Disabled
2
Create commit and host reboot jobs by using the
jobqueue
command:
$ racadm jobqueue create BIOS.Setup.1-1 -r pwrcycle
-s TIME_NOW -e TIME_NA
3
Reboot the server and let CSIOR run for the setting to take effect.
Pro.fm Page 10 Tuesday, March 5, 2013 3:27 PM