Users Guide

Rack Installation Guide 15
2 Push the mounting rail forward until the mounting hooks enter their
square holes, and then push down on the mounting-bracket flange until
the mounting hooks seat and the push button pops out and clicks
(see Figure 1-5).
3 At the back of the cabinet, pull back on the mounting-bracket flange until
the mounting hooks enter their square holes, and then push down on the
flange until the mounting hooks seat and the push button pops out and
clicks.
4 Repeat step 1 through step 3 for the mounting rail on the other side of
the rack.
NOTE: Ensure that the mounting rails are mounted at the same vertical
position on both sides of the rack.
Installing the VersaRails Mounting Rails
NOTE: Ensure that the rotating mounting brackets on the slide assemblies are
in the VersaRail configuration. See Figure 1-6.
1 At the front of the rack cabinet, position one of the mounting rails
so that its mounting-bracket flange fits between the marks you placed
(or numbered locations) on the vertical rails in "Marking the Rack"
on page 10 (see Figure 1-6).
The three holes on the front of the mounting-bracket flange should align
with the holes between the marks you made on the front vertical rail.
2 Install two 10-32 x 0.5-inch flange-head Phillips screws in the upper and
lower holes in the mounting-bracket flange to secure the mounting rail
to the front vertical rail.
3 At the back of the cabinet, pull back on the mounting-bracket flange until
the mounting holes align with their respective holes on the back vertical
rail.
4 Install two 10-32 x 0.5-inch flange-head Phillips screws in the upper and
lower holes in the mounting-bracket flange to secure the mounting rail
to the back vertical rail.
5 Repeat step 1 through step 4 for the mounting rail on the other side
of the rack.
NOTE: Ensure that the mounting rails are mounted at the same position
on the vertical rails on each side of the rack.