Owners Manual

c. right metal bracket
Figure 55. Installing the expansion card from the right expansion card riser
1. expansion card riser 2. expansion card connector on the riser
3. expansion card latch 4. expansion card
1. Install the expansion card riser.
2. Connect the cables to the expansion card.
3. Follow the procedure listed in the After working inside your system section.
4. Install any device drivers required for the card as described in the documentation for the card.
Related references
Safety instructions on page 60
Related tasks
Before working inside your system on page 61
Installing the left or right expansion card riser on page 104
After working inside your system on page 61
Network Daughter Card riser
The Network Daughter Card (NDC) riser is a half-length, full-height card installed in a dedicated PCIe slot on the system board.
It has an x16 PCIe connector (reverse orientation). The NDC riser is also known as I/O riser 1.
The NDC riser supports:
● A standard rNDC connector, which connects one Dell standard Network Daughter Card
● IDSDM connector
● Temperature sensor
● Chassis intrusion switch
Removing the Network Daughter Card riser
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
Installing and removing system components 111