Owners Manual

Figure 74. Installing the heat sink
a. heat sink
b. retention screw (4)
c. retention screw slot (4)
d. processor shield
1. Install the following:
a. Fan tray
b. Cable management tray
c. Memory riser and fan cage
d. Memory riser
e. Cooling fans
2. Install the cooling shroud.
3. Follow the procedure listed in the After working inside your system section.
4. While booting, press F2 to enter System Setup and verify that the processor information matches the new system
configuration.
5. Run the system diagnostics to verify that the new processor operates correctly.
Related references
Safety instructions on page 60
Before working inside your system on page 61
Related tasks
Installing a processor on page 129
Installing the fan tray on page 85
Installing the cable management tray on page 88
Installing the memory riser and fan cage on page 81
Installing a memory riser on page 74
Installing a cooling fan on page 83
After working inside your system on page 61
Removing a processor and heat sink blank
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the following:
a. Memory risers
b. Cooling fans
c. Memory riser and fan cage
d. Cable management tray
e. Fan tray
1. Press the release tab located at the back of the processor and heat sink blank.
2. Lift the processor and heat sink blank out of the system.
Installing and removing system components
133