Owners Manual

After working inside your system on page 61
Installing the memory riser and fan cage
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
NOTE: Before installing the memory riser and fan cage, ensure there are no loose cables from the hard drive backplane. If
the cables are not latched, the cage will not seat firmly into the chassis.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
1. Lift the memory riser and fan cage by holding the cage handle and back of the cage.
2. Align the guide rails on the memory riser and fan cage with the guides on the chassis.
3. Lower the memory riser and fan cage into the system until it is firmly seated on the system board.
4. Lower the cage handle until the cage handle locks into place.
Figure 26. Installing the memory riser and fan cage
1.
cage handle lock 2. cage handle
3. memory riser and fan cage 4. rear handle
5. guide rail (2) 6. guide on the chassis (2)
7. chassis
1. Install the following:
a. Memory risers
b. Cooling fans
c. Memory riser blanks, if removed
2. Follow the procedure listed in the After working inside your system section.
Installing and removing system components
81