Owners Manual

To locate the USB port, see the System board jumpers and connectors section.
2. If installed, remove the USB memory key from the USB port.
Figure 43. Removing the internal USB memory key
a. USB memory key
b. USB port
3. Insert the replacement USB memory key into the USB port.
Figure 44. Installing the internal USB memory key
a. USB memory key
b. USB port
1. Follow the procedure listed in the After working inside your system section.
2. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Expansion cards and expansion card risers
Your system supports third Generation 10 PCIe expansion card slots that include one dedicated slot for PERC 9 storage card
and one dedicated riser-slot for Network Daughter Card (NDC).
Expansion card installation guidelines
Slot 1 connector functions as an x8 connector and can be extended as two x4 slots when the left I/O riser is installed.
Slot 9 connector functions as an x16 connector and can be extended as two x8 slots when the right I/O riser is installed.
NOTE:
A missing or an unsupported expansion card riser logs an SEL event. It does not prevent your system from powering
on and no BIOS POST message or F1/F2 pause is displayed.
NOTE: Left and right optional risers support Generation 3 expansion cards.
Table 35. Supported expansion cards
Installing and removing system components 99