Reference Guide
Table Of Contents
- Dell EMC PowerEdge RAID Controller Command Line Interface Reference Guide
- Contents
- Overview
- Accessing the command prompt
- Working with the PERC Command Line Interface Tool
- System commands
- Controller commands
- Drive commands
- Virtual drives commands
- Add virtual drives commands
- Delete virtual drives commands
- Delete non-RAID disks
- Virtual drive show commands
- Preserved cache commands
- Change virtual drive properties commands
- Virtual drive initialization commands
- Virtual drive erase commands
- Virtual drive migration commands
- Virtual drive consistency check commands
- Background initialization commands
- Foreign configurations commands
- BIOS-related commands
- Drive group commands
- BBU commands
- Enclosure commands
- PHY commands
- Logging commands
- PERC CLI command examples
- Getting a complete list of CLI commands
- Checking controller availability
- Viewing controllers
- Viewing free space information
- Viewing disk1 information
- Viewing controller, virtual disk, and drivers information
- Checking for preserved cache
- Deleting preserved cache
- Viewing expansion information
- Viewing expansion size
- Viewing the foreign configuration
- Importing the foreign configuration
- Viewing BBU information
- Viewing physical drive details for the specified slot in the controller
- Viewing the boot drive for the controller
- Setting virtual drive as boot drive
- Locating a drive
- Stopping a locate operation
- Snapdump commands
- Getting help
- Documentation resources
perccli /cx/ex show
Input example:
perccli /c1/e1 show
perccli /cx/ex show all
This command shows the status of each model in the enclosure.
Input example:
perccli /c0/e0 show all
perccli /cx /ex show phyerrorcounters
Input example:
perccli /c0 /e0 show phyerrorcounters
perccli /cx/ex show status [extended]
This command shows the enclosure status and the status of all the enclosure elements.
Input example:
perccli /c0/e0 show status
PHY commands
The PERC Command Line Tool supports the following PHY commands:
perccli /cx/px|pall set linkspeed=0(auto)|1.5|3|6|12
perccli /cx/px|pall show
perccli /cx/px|pall show all
The detailed description for each command follows.
perccli /cx/px|pall set linkspeed=0(auto)|1.5|3|6|12
This command sets the PHY link speed. You can set the speed to 1.5 Gb/s, 3 Gb/s, 6 Gb/s, or 12 Gb/s. The linkspeed is set to
auto when you specify linkspeed = 0.
Input example:
perccli /c0/p0 set linkspeed=1.5
perccli /cx/px|pall show
This command shows the basic PHY layer information.
Input example:
perccli /c1/p0 show
perccli /cx/px|pall show all
This command shows all the PHY layer information.
48
Working with the PERC Command Line Interface Tool