Users Guide

NOTE: Ensure that you connect the cable according to the connector labels on the cable. The cable does not function

properly if reversed.

7 Route the SAS data cable through the clip on the card and through the channel on the inner side of the chassis.

8 Attach the connector labeled "BP SAS" to connector SAS A on the backplane, and attach the connector labeled "CTRL SAS" to SAS-

cable connector on the controller card.

9 Close the sled.

10 Insert the sled into the MX chassis and turn on the system and any attached MX chassis peripherals.

Removing the PERC 9 adapter

CAUTION: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple

repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.

Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions

that are shipped with your product.

NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the

system.

1 Turn o the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.

2 Open the system.

3 Locate the PERC card on the system board.

CAUTION: To prevent damage to the card, you must hold the card by its edges only.

4 Lift the card to remove it from the connector on the system board.

5 Disconnect the SAS cables connected to the card:

a Press down and hold the metal tab on the SAS cable connector.

b Pull the SAS cable out of the connector.

6 Replace the storage controller card and connect the cable. For more information on installing the card, see Installing the PERC 9

adapter.

7 Close the system.

8 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Deploying the PERC card