Users Guide

Figure 9. Removing and installing the PERC H730P MX card adapter card
1
bracket notch (3) 2 release lever
3 card bracket 4 tabs on the system
5 system chassis 6 card connector on the system board
7 PERC card connector
Installing the PERC H730P MX adapter card
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the
system.
1 Turn o the sled and any attached peripherals, and remove the sled from the MX chassis.
2 Open the sled.
3 Align the bracket notches with the tabs on the sides of the sled and align the PERC card connector with the connector on the system
board.
NOTE
: To prevent damage to the card, you must hold the card by its edges only.
4 Press the PERC card onto the connector until it is rmly seated.
5 Press the release lever to secure the card to the sled.
6 Connect the SAS data cable connector to the card.
40
Deploying the PERC card