Users Guide

Figure 13. Removing the battery

1 battery carrier 2 guide on the battery carrier (2)

3 battery 4 battery cable

8 Align the replacement battery with the guides on the battery carrier.

9 Lower the battery into the carrier until the battery clicks into place.

10 Align the tabs on the battery carrier with the slots on the PERC9 mini monolithic controller and lower the battery carrier till it clicks

into place.

11 Connect the battery cable to the PERC card.

12 Replace the PERC card. For more information, see Installing the HBA330 mini monolithic controller.

13 Close the system.

14 Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.

Installing the HBA330 mini monolithic controller

CAUTION

: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple

repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.

Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions

that are shipped with your product.

NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the

system.

1 Turn o the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2 Open the system.

3 Locate the storage controller card retention hook on the system board and insert the end of the card at an angle into the storage

controller retention hook.

CAUTION

: To prevent damage to the card, you must hold the card by its edges only.

4 Lower the storage controller card to align the screw holes on the card with the screw holes on the connector.

5 Connect the storage controller cable:

a Grasp the cable on both sides of the cable connector and connect to the HBA card.

b Tighten the screws to secure the cable and the card to the system board.

6 Connect the SAS data cable connector to the card.

Deploying the PERC card