Users Guide
Features
Topics:
• Controller features
• Virtual disk features
• Hard drive features
• Fault tolerance
Controller features
This section lists the following controller features supported on PowerEdge RAID Controller (PERC) 10 cards in detail:
● 1 MB I/O
● Auto Configure RAID 0
● Disk roaming
● Enhanced HBA mode
● FastPath
● H745P MX enclosure support
● Non-RAID disk
● Physical disk power management
● PERC H840 enclosure support
● Profile Management
● Secure firmware update
● Snapdump
1 MB I/O
PERC 10 controllers support a 1 MB I/O feature; if the capacity of I/O frame is greater than 1 MB, the I/O frame is broken into
smaller chunks.
Auto Configure RAID 0
Auto Configure RAID 0 feature creates a single drive RAID 0 on each physical disk that is in the ready state. For more
information, see Auto Configure RAID 0 on page 55.
Disk roaming
Disk roaming is when a physical disk is moved from one cable connection or backplane slot to another on the same controller.
The controller automatically recognizes the relocated physical disks and logically places them in the virtual disks that are part of
the disk group.
CAUTION: It is recommended that you perform disk roaming when the system is turned off.
CAUTION: Do not attempt disk roaming during RAID level migration (RLM) or online capacity expansion (OCE).
This causes loss of the virtual disk.
Using disk roaming
Perform the following steps to use disk roaming:
3
16 Features