Reference Guide

Table 3. Properties for show and set commands (continued)
Property name Set command range Description
prrate
0 to 100 Sets patrol read rate of the virtual
drives in percentage.
rebuildrate
0 to 100 Sets rebuild rate of the drive in
percentage.
reconrate
0 to 100 Sets reconstruction/migration rate
for a drive in percentage.
restorehotspare on|off
Becomes a hot spare on insertion
of a failed drive.
smartpollinterval
0 to 65535 Set time for polling of SMART
errors in seconds.
spinupdrivecount
0 to 255 Sets number of drives that are
spun up at a time.
spinupdelay
0 to 255 Sets spin-up delay between a group
of drives or a set of drives, in
seconds.
stoponerror on|off
Stops the MegaRAID BIOS during
POST, if any errors are
encountered.
time
Valid time in yymmdd hh:mm:ss format or systemtime Sets the controller time to your
input value or the system time
(local time in 24-hour format).
usefdeonlyencrypt on|off
Enables/disables FDE drive-based
encryption.
Controller show commands
The PERC Command Line Tool supports the following show commands:
perccli /cx show
perccli /cx show all
perccli /cx show freespace
perccli /cx show personality
The detailed description for each command follows.
perccli /cx show personality
This command shows the personality set on the controller. eHBA mode lists the personality as eHBA.
Input example:
perccli /c1 show personality
perccli /cx show [jbod]
This command shows the summary of the controller information. The summary includes basic controller information, foreign
configurations, drive groups, virtual drives, physical drives, enclosures, and BBU information. If you use the JBOD option, the
command shows all Non-RAID disk(s) displayed in JBOD list. If the physical disk is Non-RAID, its type is set as JBOD and its
state as Online.
Input example:
perccli /c1 show
12
Working with the PERC Command Line Interface Tool