Reference Guide

perccli /cx[/ex]/sx show rebuild

This command shows the progress of the rebuild process in percentage.

Input example:

perccli /c0/s5 show rebuild

perccli /cx[/ex]/sx start rebuild

This command starts a rebuild operation for a drive.

Input example:

perccli /c0/s4 start rebuild

perccli /cx[/ex]/sx stop rebuild

This command stops a rebuild operation. You can run this command only for a drive that is currently rebuilt.

Input example:

perccli /c0/s4 stop rebuild

Drive copyback commands

The PERC Command Line Tool supports the following commands for drive copyback:

perccli /cx[/ex]/sx pause copyback

perccli /cx[/ex]/sx resume copyback

perccli /cx[/ex]/sx show copyback

perccli /cx[/ex]/sx start copyback target=e:s

perccli /cx[/ex]/sx stop copyback

NOTE: In the copyback commands,cx[/ex]/sx indicates the source drive and e:s indicates the target drive.

perccli /cx[/ex]/sx pause copyback

This command pauses a copyback operation. You can run this command only when there is a copyback operation running.

Input example:

perccli /c0/e25/s4 pause copyback

perccli /cx[/ex]/sx resume copyback

This command resumes a paused copyback operation. You can run this command only when there is a paused copyback process

for the drive.

Input example:

perccli /c0/e25/s4 resume copyback

perccli /cx[/ex]/sx show copyback

This command shows the progress of the copyback operation in percentage.

Input example:

perccli /c0/e25/s4 show copyback

Working with the PERC Command Line Interface Tool