Reference Guide

perccli /cx/bbu set <options>
This command sets bbu properties on the controller bbu.
Options:
● learnDelayInterval=<val>: number of hours to delay a learn cycle, not greater than 7 days
● bbuMode=<val>: val range 0–255
● autolearnmode=<val>: 0 — Enabled, 1 — Disabled, 2 — WarnViaEvent
● learnStartTime=[DD HH|off>: DDD — day of week {SUN, MON, . . . SAT} HH — 0–23 hours, off: Sets learn start to OFF
● powermode=sleep
● writeaccess=sealed
perccli /cx/bbu show
This command shows the summary information for the BBU of a controller.
Input example:
perccli /c0/bbu show
perccli /cx/bbu show all
This command shows all the information of a BBU.
Input example:
perccli /c0/bbu show all
perccli /cx/bbu show learn
perccli /cx/bbu show properties
This command shows the BBU Learn properties for a controller.
Input example:
perccli /c0/bbu show properties
perccli /cx/bbu show status
This command shows summary information for the BBU of a controller.
Input example:
perccli /c0/bbu show status
perccli /cx/bbu start learn
This command starts the BBU learning cycle.
Input example:
perccli /c0/bbu start learn
Working with the PERC Command Line Interface Tool
47