Reference Guide

13 Boot Drive On Success 0 -
----------------------------------------------
Locating a drive
Syntax
perccli /c0/e32/s0 start locate
Description
Locates a drive and activates the physical disk activity LED.
Result
Controller = 0
Status = Success
Description = Start Drive Locate Succeeded
Stopping a locate operation
Syntax
perccli /c0/e32/s0 stop locate
Description
Stops a drive locate operation and deactivates the physical disk activity LED.
Result
Controller = 0
Status = Success
Description = Stop Drive Locate Succeeded
Snapdump commands
The PERC Command Line Tool supports the following commands for snapdump state, save count, collection, and deletion.
NOTE: The PERC H345 controller can hold a maximum of one snapdump at a time.
perccli /cx show snapdump
perccli /cx set snapdump state=on|off
perccli /cx set snapdump [ savecount=<value> | delayocr=<value> ]
perccli /cx get snapdump [ id=[ all | <value> file=<filename>] ] [norttdump]
perccli /cx delete snapdump force
The detailed description for each command follows.
Working with the PERC Command Line Interface Tool
61