Users Guide

5 Lower the H730P slim card into the chassis until the slots on the card engage with the standos on the side of the chassis.
6 Press the release latch to the lock position to secure the card rmly on the chassis.
The H730P slim card connects to the backplane connector.
7 Hold the pull tag on the H730P slim card cable connector and route the cable between the memory-module ejectors.
8 Align the retention screws on the H730P slim card cable connector with the screw holes on the system board connector.
9 Tighten the two retention screws to secure the H730P slim card cable connector on the system board.
Removing the PERC 9 mini blade controller
1 Turn o the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior
of the system.
2 Open the system.
3 Locate the PERC card on the system board.
4 Loosen the two retention screws on the hard-drive/SSD backplane cable connector and lift it away from the PERC 9 mini blade
controller.
CAUTION: To prevent damage to the PERC 9 mini blade controller, you must hold the card by its edges only.
5 Lift the PERC 9 mini blade controller up and out of the connector.
6 Replace the storage controller card and connect the cable. For more information on installing the card, see Installing the PERC 9 mini
blade controller.
7 Close the system.
8 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Figure 16. Removing and installing the PERC 9 mini blade controller
1
hard-drive/SSD backplane cable connector 2 slot on the PCIe extender/storage controller card
50 Deploying the PERC card