Users Guide

Figure 22. Removing the battery
1
PECR FD33xD card 2 battery carrier
3 battery cable 4 battery
8 Install the replacement battery on the controller.
9 Push the battery carrier toward the battery and slide the battery carrier till it clicks into place.
10 Connect the battery cables to the PERC card.
11 Replace the PERC card. For more information, see Installing the PERC FD33xD card.
12 Close the system.
13 Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.
Installing the PERC FD33xD card
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the
system.
NOTE: PERC FD33xS and FD33xD cards are supported only on PowerEdge FD332 system. The procedure for installing a PERC
FD33xS card is identical to installing a PERC FD33xD card.
1
Turn o the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2 Open the system.
3 Align the PERC card with the connector on the midplane interface module.
4 Lower the PERC card until it is rmly seated on the connector on the midplane interface module.
5 Install the screws to secure the PERC card to the PERC card holder on the midplane interface module.
6 Holding the cable touch point, align the cable guide pins with the holes on the PERC card.
7 Tighten the screws to secure the cable to the PERC card.
56
Deploying the PERC card