Instruction Manual


Installing the Bezel

1. Align the three bezel release tabs with the system's front panel.

2. Press the bezel onto the system until it snaps into place.

3. Install the screw that secures the bezel to the front panel. See FigureC-1.

4. Install any 5.25-inch optical or tape drives that you removed to gain access to the bezel release tab. See "5.25-Inch Optical and Tape Drives" in
"Installing Drives."

5. Close the system. See "Closing the System" in "Troubleshooting Your System."

6. Reconnect the system to the electrical outlet, and turn on the system.
Control Panel

Removing the Control Panel


1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.

2. Open the system. See "Opening the System" in "Troubleshooting Your System."

3. Remove the bezel. See "Removing the Bezel."

4. Disconnect the control panel cable that connects to the I/O panel. See FigureC-2.

5. Using a #2 Phillips screwdriver, remove the screw that secures the control panel to the front panel. See FigureC-2.
Figure C-2. Removing and Installing the Control Panel
CAUTION: See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.