User Manual


6. Carefully pull the control panel cable through the front panel while removing the control panel.

Installing the Control Panel

1. Carefully slide the control panel cable through the front panel.

2. Slide the control panel into the two slots in the securing bracket on the front panel. See Figure1-2.

3. Align the control panel mounting hole with the hole in the front panel.

4. Using a #2 Phillips screwdriver, install the screw that secures the control panel to the front panel.

5. Connect the control panel cable to the I/O panel. See Figure1-3.

6. Install the bezel. See "Installing the Bezel."

7. Close the system.

8. Reconnect the system to the electrical outlet, and turn on the system.
I/O Panel

Removing the I/O Panel


1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.

2. Open the system.

3. Disconnect the following cables from the I/O panel:
l Control panel
l Chassis intrusion switch
l I/O panel

4. Using a #2 Phillips screwdriver, remove the screw that secures the I/O panel to the chassis. See Figure1-3.
Figure 1-3. Removing and Installing the I/O Panel
CAUTION: See your System Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.