Owner`s manual
Table Of Contents
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Opening the System
- Closing the System
- Front Drive Bezel
- Removing and Inserting Blank Drive Inserts
- Diskette Drive
- Optical and Tape Drives
- Hard Drives
- Expansion Cards
- Memory
- Microprocessor
- Cooling Fans
- System Battery
- Power Supply
- Chassis Intrusion Switch
- Bezel
- I/O Panel Assembly
- System Board
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Troubleshooting the Keyboard or Mouse
- Troubleshooting Serial I/O Problems
- Troubleshooting a NIC
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting Power Supply
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting a Diskette Drive
- Troubleshooting an Optical Drive
- Troubleshooting an External SCSI Tape Drive
- Troubleshooting a Hard Drive
- Troubleshooting a SAS or SAS RAID Controller
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessor
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
Installing System Components 101
Figure 3-31. Cabling the I/O Panel Assembly
4
Replace the large processor cooling fan. See "Replacing the Cooling Fans"
on page 87.
5
Replace the heat sink and shroud assembly. See "Replacing the Processor"
on page 83.
NOTE: To prevent damaging the processor, clean the heat sink to remove any
thermal grease and then apply fresh thermal grease to the processor before
installing the heat sink.
1 I/O panel connector 2 front drive bezel
3 I/O panel assembly 4 4-pin power cable to system board
5 cable clip on power supply 6 I/O panel ribbon cable
5
3
6
1
4
2
book.book Page 101 Wednesday, June 24, 2009 8:21 AM