Owner`s manual
Table Of Contents
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Opening the System
- Closing the System
- Front Drive Bezel
- Removing and Inserting Blank Drive Inserts
- Diskette Drive
- Optical and Tape Drives
- Hard Drives
- Expansion Cards
- Memory
- Microprocessor
- Cooling Fans
- System Battery
- Power Supply
- Chassis Intrusion Switch
- Bezel
- I/O Panel Assembly
- System Board
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Troubleshooting the Keyboard or Mouse
- Troubleshooting Serial I/O Problems
- Troubleshooting a NIC
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting Power Supply
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting a Diskette Drive
- Troubleshooting an Optical Drive
- Troubleshooting an External SCSI Tape Drive
- Troubleshooting a Hard Drive
- Troubleshooting a SAS or SAS RAID Controller
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessor
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
Using the System Setup Program 43
NOTE: You can use the Password Status option in conjunction with the Setup
Password option to protect the system password from unauthorized changes.
Deleting or Changing an Existing Setup Password
1
Enter the System Setup program and select the
System Security
option.
2
Highlight the
Setup Password
option, press <Enter> to access the setup
password window, and press <Enter> twice to clear the existing setup
password.
The setting changes to
Not Enabled
.
3
If you want to assign a new setup password, perform the steps in "Assigning
a Setup Password" on page 42.
Disabling a Forgotten Password
See "Disabling a Forgotten Password" on page 139.
book.book Page 43 Wednesday, June 24, 2009 8:21 AM