Owner`s manual
Table Of Contents
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Opening the System
- Closing the System
- Front Drive Bezel
- Removing and Inserting Blank Drive Inserts
- Diskette Drive
- Optical and Tape Drives
- Hard Drives
- Expansion Cards
- Memory
- Microprocessor
- Cooling Fans
- System Battery
- Power Supply
- Chassis Intrusion Switch
- Bezel
- I/O Panel Assembly
- System Board
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Troubleshooting the Keyboard or Mouse
- Troubleshooting Serial I/O Problems
- Troubleshooting a NIC
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting Power Supply
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting a Diskette Drive
- Troubleshooting an Optical Drive
- Troubleshooting an External SCSI Tape Drive
- Troubleshooting a Hard Drive
- Troubleshooting a SAS or SAS RAID Controller
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessor
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
Installing System Components 71
5
Grasp the card by its top corners and ease it out of its connector.
6
If you are removing the card permanently, install a filler bracket in the
empty card slot.
NOTE: Filler brackets must be installed over empty expansion card slots to
maintain Federal Communications Commission (FCC) certification of the
system. The brackets also keep dust and dirt out of the system and aid in
proper cooling and airflow inside the system.
book.book Page 71 Wednesday, June 24, 2009 8:21 AM