Owner`s manual
Table Of Contents
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Opening the System
- Closing the System
- Front Drive Bezel
- Removing and Inserting Blank Drive Inserts
- Diskette Drive
- Optical and Tape Drives
- Hard Drives
- Expansion Cards
- Memory
- Microprocessor
- Cooling Fans
- System Battery
- Power Supply
- Chassis Intrusion Switch
- Bezel
- I/O Panel Assembly
- System Board
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Troubleshooting the Keyboard or Mouse
- Troubleshooting Serial I/O Problems
- Troubleshooting a NIC
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting Power Supply
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting a Diskette Drive
- Troubleshooting an Optical Drive
- Troubleshooting an External SCSI Tape Drive
- Troubleshooting a Hard Drive
- Troubleshooting a SAS or SAS RAID Controller
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessor
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
72 Installing System Components
Figure 3-18. Removing and Installing an Expansion Card
7
Close the card retention door to secure the remaining card(s) in the
system. See Figure 3-18.
8
Close the system. See "Closing the System" on page 47.
9
Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
10
Remove the card’s device driver from the operating system.
1 expansion card 2 alignment guide
3 card retention door 4 release tab
2
4
3
1
book.book Page 72 Wednesday, June 24, 2009 8:21 AM