Owners Manual

72 Installing System Components
Figure 3-11. Removing or Installing a Hard Drive From a Hard Drive Bracket
Expansion Card Stabilizer
Removing the Expansion Card Stabilizer
1 Turn off the system and attached peripherals. Disconnect the system from
the electrical outlet and peripherals.
2 Open the system. See "Opening the System" on page 57.
3 Press the release tab and lift the expansion card stabilizer out of slots in the
chassis. See Figure 3-12.
Installing the Expansion Card Stabilizer
1 Slide the edge of the expansion card stabilizer into the slots in the cooling
shroud and chassis until the release tab locks into place. See Figure 3-12.
1 hard drive 2 hard drive bracket
3 blue tabs (2)
3
1
2
Mayzie_HOM.book Page 72 Monday, August 31, 2009 9:33 PM