CLI Guide

• To generate and view information about the inventory of EMMs, run the following command:

racadm storage get emms -refkey <enclosure FQDDs separated by comma>

racadm storage get emms --refkey <enclosure FQDDs separated by comma> -o

racadm storage get emms --refkey <enclosure FQDDs separated by comma> -o -p

• To generate and view information about the inventory of PSU, run the following command:

racadm storage get psus -refkey <enclosure FQDDs separated by comma>

racadm storage get psus --refkey <enclosure FQDDs separated by comma> -o

racadm storage get psus --refkey <enclosure FQDDs separated by comma> -o -p

Configuration

• To view the help details for a configuration command, run the following command:

racadm storage help <command>

where command can take below values

converttoraid, converttononraid, controllers, clearconfig,

createsecuritykey, createvd, deletesecuritykey,

deletevd, encryptvd, enclosures, emms, fans, hotspare, importconfig,

ccheck, cryptographicerase, preparetoremove, blink, unblink, cancelcheck,

renamevd, cancelbgi, rebuild, cancelrebuild, capacityexpanon,

raidlevelmigrationinit, modifysecuritykey, psus, pdisks, resetconfig,

tempprobes, vdisks, patrolread, forceonline,

forceoffline,replacephysicaldisk,unlock,and setbootvd.

NOTE:

iSM must be running on the operating system to run the preparetoremove method

• To create, delete, and secure the virtual disks. To start or stop the consistency check on the specified virtual

disk, run the following command:

racadm storage createvd:<Controller FQDD> -rl {r0|r1|r5|r6|r10|r50|r60}[-wp

{wt|wb|wbf}] [-rp {nra|ra|ara}] [-ss {1k|2k|4k|8k|16k|32k|64k|128k|256k|

512k|1M|2M|4M|8M|16M}]-pdkey:<comma separated PD FQDD> [-dcp {enabled|

disabled|default}] [-name <VD name>] [-size <VD size>{b|k|m|g|t}] [-

T10PIEnable]

120

RACADM Subcommand Details