CLI Guide

Output
Success: Test trap sent successfully
Failure: Unable to send test trap
Example
• Test a trap with index as 1.
racadm testalert -i 1
Test trap sent successfully.
• Test a trap that has not been configured yet.
racadm testalert -i 2
ERROR: Trap at specified index is not currently enabled.
traceroute
Table 107. Details of traceroute
Description Traces network path of the routers as the packets traverse from the system to a destination IPv4 address.
To run this subcommand, you must have the Execute Diagnostic Commands permission.
Synopsis
racadm traceroute <IPv4 address>
Input IPv4 — Specifies IPv4 address.
Output
traceroute to 192.168.0.1 (192.168.0.1), 30 hops max, 40 byte packets
1 192.168.0.1 (192.168.0.1) 0.801 ms 0.246 ms 0.253 ms
traceroute6
Table 108. Details of traceroute6
Description Traces the network path of routers as the packets traverse from the system to a destination IPv6 address.
To run this subcommand, you must have the Execute Diagnostic Commands permission.
Synopsis
racadm traceroute6 <IPv6address>
Input <IPv6address> – Specifies IPv6 address.
Output
traceroute to fd01::1 (fd01::1) from fd01::3,
30 hops max, 16 byte packets
1 fd01::1 (fd01::1) 14.324 ms 0.26 ms 0.244 ms
150 RACADM Subcommand Details