CLI Guide

• Example 3:

racadm> getl<press tab>

racadm> getled <press enter> or <racadm getled>

LEDState: Not-Blinking

• Example 4:

racadm>> get bios.uefiBootSettings

BIOS.UefiBootSettings

BIOS.UefiBootSettings.UefiBootSeq

BIOS.UefiBootSettings.UefiPxeIpVersion

NOTE: In the RACADM autocomplete mode, certain RACADM commands may not be listed inline with the platforms. In

such scenarios, execute the RACADM command in the normal execution mode.

NOTE: In the RACADM autocomplete mode, type the commands directly without giving racadm as prefix.

NOTE: The RACADM get or set attributes with value length up to 512 characters are supported from autocomplete

mode. If the value length is 512 characters or more, execute the RACADM command in the normal execution mode.

Lifecycle Controller Log

Lifecycle Controller logs provide the history of changes related to components installed on a managed system. You can also add work

notes to each log entry.

The following events and activities are logged:

• System events

• Storage devices

• Network devices

• Configuration

• Audit

• Updates

You can view and filter logs based on the category and severity level. You can also export and add a work note to a log event.

If you initiate configuration jobs using RACADM CLI or iDRAC web interface, the Lifecycle log captures the information about the user,

interface used, and the IP address of the system from which you initiate the job.

Unsupported RACADM Subcommands

The following table provides the list of RACADM subcommands which are not supported.

Table 2. Unsupported RACADM Subcommands

Subcommand iDRAC on Blade Servers

Telnet/SSH/Serial

krbkeytabupload No

sslcertupload No

sslkeyupload No

usercertupload No

Proxy parameters

Some commands do not support setting the proxy parameters if the share location (-l) is HTTP/HTTPS. To perform the operation with

HTTP or HTTPS through a proxy, the proxy parameters must be first configured using the lifecyclecontroller.lcattributes. Once these

proxy parameters are configured, they become the part of default configuration; the proxy attributes should be cleared to end use of the

HTTP/HTTPS proxy.

Introduction