CLI Guide

• Configure a RAC from a configuration file:
racadm config -f config.txt
• Configure a RAC from a configuration file and continue if a group fails to get configured:
racadm set -f config.txt --continue
coredump
Table 15. Details of coredump
Description Displays detailed information related to any recent critical issues that have occurred with iDRAC. The
coredump information can be used to diagnose these critical issues.
If available, the coredump information is persistent across iDRAC power cycles and remains available until
either of the following conditions occur:
The coredump information is deleted using the coredumpdelete subcommand.
For more information about clearing the coredump, see the coredumpdelete.
NOTE: To use this subcommand, you must have the Execute Debug privilege.
Synopsis
racadm coredump
Example
• racadm coredump
There is no coredump currently available.
• racadm coredump
Feb 19 15:51:40 (none) last message repeated 5 times
Feb 19 15:52:41 (none) last message repeated 4 times
Feb 19 15:54:12 (none) last message repeated 4 times
Feb 19 15:56:11 (none) last message repeated 2 times
Feb 22 11:46:11 (none) kernel:
coredumpdelete
Table 16. Details of coredumpdelete
Description Deletes any currently available coredump data stored in the RAC.
To use this subcommand, you must have Execute Debug Command permission.
NOTE: If a coredumpdelete command is issued and a coredump is not currently stored in the RAC,
the command displays a success message. This behavior is expected. See the coredump
subcommand for more information about viewing a coredump.
Synopsis
racadm coredumpdelete
Output
Coredump is deleted.
Example
racadm coredumpdelete
Coredump request completed successfully
52 RACADM Subcommand Details