CLI Guide

• idrac.alert.all

• idrac.alert.audit

•

idrac.alert.audit.lic

• idrac.alert.audit.warning

• idrac.alert.audit.lic.critical

This command does not support setting the proxy parameters if the share location (-l) is HTTP/HTTPS. For more

information, see Proxy parameter section.

Input • get—Displays the list of eventfilter settings

• set—Configures the actions and notifications for a given eventfilter configuration

• -i—Message ID for which the simulation is needed

• -c—Alert category of the specific event filter

• -a—The action that must be invoked when the event occurs. Valid values are none, powercycle, power

off, or systemreset

• -n—The notification is sent when the event occurs. Valid values are all, snmp, ipmi, ws-events,

redfish-events, oslog, email, remotesyslog, or none. You can append multiple notifications that

are separated by a comma. You cannot enter the values all or none with other notifications. If incorrect

notification is specified along with other valid notifications, the valid and invalid notification set is failed.

• -r—Event generation interval. This option is applicable only to the temperature statistics subcategory tmps.

You can use this option as a stand-alone or with -n and -a.

NOTE: If both event generation interval and notifications are configured and there is an error while

configuring the notifications, the event generation interval is not set. The valid values are 0–365. 0

disables the event generation.

Example • Display all available event filter configurations.

racadm eventfilters get -c idrac.alert.all

• Display eventfilter configurations for a specific category. For example, audit

racadm eventfilters get -c idrac.alert.audit

• Display eventfilter configurations for a specific subcategory. For example, licensing under the audit category

racadm eventfilters get -c idrac.alert.audit.lic

• Display eventfilter configurations for a specific severity. For example, warning under the audit category

racadm eventfilters get -c idrac.alert.audit.warning

• Display eventfilter configurations for a specific severity and subcategory. For example, a severity of warning in

the subcategory licensing under audit category

racadm eventfilters get -c idrac.alert.audit.lic.warning

• Clear all available alert settings.

racadm eventfilters set -c idrac.alert.all -a none -n none

• Configure using severity as a parameter. For example, all informational events in storage category are assigned

power off as action, and email and SNMP as notifications.

racadm eventfilters set -c idrac.alert.storage.info -a poweroff -n

email,snmp

• Configure using subcategory as a parameter. For example, all configurations under the licensing subcategory in

the audit category are assigned power off as action and all notifications are enabled.

racadm eventfilters set -c idrac.alert.audit.lic -a poweroff -n all

RACADM Subcommand Details